If you are trying to learn more about how to measure activated bleaching earth bulk density, then the following should help you understand how you can find out the bulk density of activated bleaching earth. Bulk density refers to the property of the powders that are found in activated bleaching earth. This bulk density can be defined as product of dividing the mass of powders found in fuller’s earth by the total volume occupied by the powders.

 

There is need to check the bulk density of activated bleaching earth because if the density is too light it can cause the refinery filtering process to be jammed. At the same time, if the bulk density of activated bleaching earth is too high it can reduce the power to bleach and will cause a severe decolorization of oil.

 

Bulk density shows whether the mesh of fuller’s earth happens to be too rough or too smooth. The ideal bulk density of fuller’s earth is anything between 0.5 and 0.6 gram/ml. here are a few tips to help you understand how to measure activated bleaching earth bulk density.

The first step requires you to weigh the glass measuring laboratory. Ideally, the weight should be one hundred grams. Take the glass measuring laboratory and fill it with fuller’s earth until a volume of ten milliliters is achieved. Next, you have to take another measurement of the weight of the glass measuring laboratory. This time you have to weigh the glass measuring laboratory after it has been filled with fuller’s earth. The weight could be 105 grams.

 

This shows that the weight of the powder in the activated bleaching earth has a volume of five grams. This figure is obtained by subtracting the weight of the glass measuring laboratory with fuller’s earth from the weight of the glass measuring laboratory without the fuller’s earth.

 

This shows that the bulk density of the activated bleaching earth is five grams divided by ten milliliters which translates to 0.5 grams per milliliter. This is how to measure activated bleaching earth bulk density. The steps involved are quite simple and anyone can follow them. The important thing to note is that you need to use the correct glass measuring laboratory and you also need to use the right amount of fuller’s earth. As long as you take care of these issues, you will not have any difficulty in learning how to measure activated bleaching earth bulk density.